Aquabot PURA SERIES Product Settings And Troubleshooting Manual

Robotic pool cleaner

Advertisement

Quick Links

820408
PURA SERIES
ROBOTIC POOL CLEANER
PRODUCT SETTINGS AND TROUBLESHOOTING GUIDE
PLEASE READ CAREFULLY BEFORE
USING YOUR POOL CLEANER
Aqua Products, Inc
282 Grove Avenue
Cedar Grove, NJ 07009
United States

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PURA SERIES and is the answer not in the manual?

Questions and answers

Summary of Contents for Aquabot PURA SERIES

  • Page 1 820408 PURA SERIES ROBOTIC POOL CLEANER PRODUCT SETTINGS AND TROUBLESHOOTING GUIDE PLEASE READ CAREFULLY BEFORE USING YOUR POOL CLEANER Aqua Products, Inc 282 Grove Avenue Cedar Grove, NJ 07009 United States...
  • Page 2: Power Supply

    product settings and troubleshooting WArnings WArning: Do not turn the Power Supply on, unless the pool cleaner is in the water. WArning: Do not operate your machine while people swim in the pool. WArning: The Power Supply must be placed at least 12 feet / 4 meters from the pool’s edge at all times! See diagram below. WArning: To prevent possible electric shock hazard this unit must be connected to an RCD (Residual Current Device) with a related residual operating current not exceeding 30mA.
  • Page 3 product settings and troubleshooting There are 2 possible configurations that the axle can be locked into. With the product settings cleaner flipped over and movable axle furthest away, the axle must always be set in front of the pin. See the diagram below. AXle And turning pins Your cleaner moves about your pool by way of 1 adjustable pin located on each end of the axle on the bottom side of the cleaner.
  • Page 4 product settings and troubleshooting Top View of Inside the cleaner product settings re-instAlling Filter bAgs AFter cleAning After you have cleaned the filter bags of the collected debris, you’ll need to re-install them back into the cleaner. Make sure the elastic opening covers all the way over the opening and that the Velco®...
  • Page 5 product settings and troubleshooting AdJusting the suction ports Your cleaner is equipped with two adjustable suction ports on the underside of the unit. Both can be lowered to maximize the suction strength for picking up smaller debris. The suction ports are set to the lowest position by default. Underside view of the cleaner showing To adjust the ports, turn the cleaner over and use a Phillips head screw driver location of adjustable suction ports...
  • Page 6 setting the poWer supplY to eXternAl tiMer Mode In order to use an external timer with the power supply, please make sure that the timer is plugged into the GFCI outlet. Then plug the power supply into the timer and then the floating cable into the power supply socket. Once this is complete, execute the following: ON / Press and release the ON/OFF to turn ON the...
  • Page 7 Should you need help with an issue that is not described in this manual, please the number below. cAll custoMer serVice At 800-221-1750 You may also download the Quick Start Guide as well as the Settings and Troubleshooting Manual at: www.Aquabot.com...
  • Page 8 Aqua Products, Inc 282 Grove Avenue Cedar Grove, NJ 07009 United States...

Table of Contents