Table of Contents
Advertisement
Do not wipe the Transmitter with
solvent. It may cause failure.
To clean the Transmitter, first wipe
away lightly with a clean soft cloth
damped by diluted mild detergent
solution and then wipe off moisture
with a dry clean soft cloth.
Keep
the
Power
off
during
installation and wiring operations.
There
are
high
voltage parts inside
the
Transmitter.
Failure to observe
this precaution may
cause fire or an
electric shock.
Make sure that the Cover is locked
without fail. Otherwise, protective
structure may not function adequately.
100 to 240 VAC
Be sure to use the power supply of
100 to 240 VAC.
Otherwise it may cause fire or
electric shock.
Do not give a strong shock to the
Transmitter.
Do not press the CLEAN button, while
the SS Checker ( Detector ) is in the air.
Precautions which are the cause of failure:
"
" denotes "Prohibited action", and "
Use Cable Clamps attached to the
transmitter for wiring. When the piping
are directly connected with the
transmitter, take a corrective action
such as caulking against intrusion of
gas because corrosive gas is in danger
of intruding through the piping, etc. into
the Transmitter.
Install the transmitter at a place
ventilating well and avoiding direct
sunlight.
" denotes "Required action".
Do not bind the signal output cable with
the power cable or do not put them in
the one Cable Clamp.
Install the transmitter
with attached
Mounting Bracket.
Advertisement
Table of Contents
