Optex SS Checker SC-T4 Instruction Manual page 10

Alarm Timer Setting
Alarm Timer can be set for 1 to 120 minutes or OFF.
Setting unit is 1 minute.
The Alarm Timer is set for OFF as a factory setting.
Ex: To set the Alarm Timer for 60 minutes ;
1
Press and select the Alarm Timer.
2 Press for 2 seconds or more, the
Alarm Timer Indicator blinks.
3
Enter "60" on the Display.
Reference Move the digit to be entered using the right and left arrow buttons
( 0.1 digit
1 digit
At this time, the selected digit blinks.
Enter a numerical value ( 0, 1, 2, ..., 9 ) into the selected digit using the
upper and lower arrow buttons
value and button decreases the value.
While pressing
changed.
To cancel the Alarm Timer Setting, press
Reference:
4 Press to terminate the Alarm Timer Setting.
Reference To change the Display for the Measurements Indication mode, press
.
Reference:
When Err6 is displayed, the value is out of the setting range.
100 digit ) .
10 digit
. button increases a numeric
buttons, the values displayed are continuously
.
2 Signal Output Response Time Setting
Signal Output Response Time can be set for 1 to 120 seconds or OFF.
Setting unit is 1 second
The Signal Output Response Time is set for OFF as a factory setting.
Ex: To set the The Signal Output Response Time for 10 seconds ;
1 Press
Output Response
Pip
2
Press
The Signal Output Response Time
Pip Pip
Indicator blinks.
3 Enter "10" on the Display.
Reference Move the digit to be entered using the right and left arrow buttons
( 0.1 digit
At this time, the selected digit blinks.
Enter a numerical value ( 0, 1, 2, ..., 9 ) into the selected digit using the
upper and lower arrow buttons
value and
While pressing
changed.
To cancel the Signal Output Response Time Setting, press
Reference:
4 Press
Setting.
Reference To change the Display for the Measurements Indication mode, press
Reference:
When Err6 is displayed, the value is out of the setting range.
and select the The Signal
Time.
for 2 seconds or more, the
100 digit ) .
1 digit 10 digit
.
button decreases the value.
buttons, the values displayed are continuously
to terminate the Signal Output Response Time
.
Pip
Pip Pip
button increases a numeric
.