Table of Contents
Advertisement
Field
Disable
Enable/Disable the Wireless LAN Interface.
Wireless LAN
Default: Disable
Interface
Band
Specify the WLAN Mode to 802.11b/g Mixed mode, 802.11b mode or
802.11g mode
Mode
Configure the Wireless LAN Interface to AP, Client, WDS, AP + WDS or
WISP mode
Network Type
Configure the Network Type to Infrastructure or Ad hoc.
SSID
Specify the network name.
Each Wireless LAN network uses a unique Network Name to identify the
network. This name is called the Service Set Identifier (SSID). When you
set up your wireless adapter, you specify the SSID. If you want to
connect to an existing network, you must use the name for that
network. If you are setting up your own network you can make up your
own name and use it on each computer. The name can be up to 20
characters long and contain letters and numbers.
Channel Width
Choose a Channel Width from the pull-down menu.
Control
Choose a Control Sideband from the pull-down menu.
Sideband
Channel
Choose a Channel Number from the pull-down menu.
Number
Broadcast SSID
Broadcast or Hide SSID to your Network.
Default: Enabled
WMM
Enable/disable the Wi-Fi Multimedia (WMM) support.
Data Rate
Select the Data Rate from the drop-down list
TX restrict / RX
Configure the TX restrict / RX restrict
restrict
Associated
Show Active Wireless Client Table
Clients
This table shows the MAC address, transmission, receiption packet
counters and encrypted status for each associated wireless client.
Enable Mac
Enable Mac Clone (Single Ethernet Client)
Clone (Single
Ethernet Client)
Enable
Acting as AP and client simultaneously
Universal
Repeater Mode
When mode is set to "AP" and URM (Universal Repeater Mode ) is
SSID of
enabled, user should input SSID of another AP in the field of "SSID of
Extended
Extended Interface". Please note, the channel number should be set to
Interface
the one, used by another AP because 8186 will share the same channel
between AP and URM interface (called as extended interface hereafter).
Description
44
Advertisement
Table of Contents
