Knife Setting Jig; Dust Port - Grizzly G0604 Owner's Manual

Knife Setting Jig

Components and Hardware Needed:
Knife Setting Jig Rod ......................................... 1
Knife Setting Jig Foot ........................................ 2
E-Clip ................................................................. 4
Assemble the knife setting jig as shown in Figure
19.
Figure 19. Knife setting jig assembly.
G0604 6" X 56" Jointer
Components and Hardware Needed:
Qty

Dust Port ........................................................... 1

Phillips Screws M5-.8 x 16 ................................ 4
Flat Washers 5mm ............................................ 4
Install the dust port as shown in Figure 20.
Figure 20. Installing dust port.
DO NOT operate the Model G0604 with-
out an adequate dust collection system.
This machine creates substantial amounts
of wood dust while operating. Failure to use
a dust collection system can result in short
and long-term respiratory illness.
Recommended CFM at Dust Port:
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must take into account
many variables, including the CFM rating of the
dust collector, the length of hose between the
dust collector and the machine, the amount of
branches or wyes, and the amount of other open
lines throughout the system. Explaining this cal-
culation is beyond the scope of this manual. If you
are unsure of your system, consult an expert or
purchase a good dust collection "how-to" book.
Dust Port
Qty
400 CFM
-19-