Table of Contents
Advertisement
MAINTENANCE
REMOVING FIREBRICK
To remove fi rebrick, lift up from bottom and rotate outward. See Figure 14.
GLASS CARE
REPLACE GLASS ONLY WITH HIGH TEMPERATURE CERAMIC
AVAILABLE FROM YOUR LOCAL LEXINGTON FORGE DEALER
The following use and safety tips should be observed:
1.
Inspect the glass regularly for cracks and breaks. If you detect a crack
or break, extinguish the fi re immediately, and contact your dealer for
replacement.
2.
Do not slam door or otherwise impact the glass. When closing doors, make sure that logs or other objects do not protrude to
impact the glass.
3.
Do not clean the glass with materials which may scratch (or otherwise damage) the glass. Scratches on the glass can develop into
cracks or breaks.
4.
Never attempt to clean the glass while unit is hot. Light deposits are normal. Heavier deposits may be removed with the use of a
readily available oven cleaner.
5.
Never put substances which can ignite explosively in the unit since even small explosions in confi ned areas can blow out the
glass.
6.
This unit has an air wash systems, designed to reduce deposits on glass.
GASKET REPLACEMENT
After extensive use, the sealing material which provides glass and door seal may need to be replaced if it fails to sustain its resilience.
Inspect glass and door seal periodically to ensure proper seal: if gaskets become frayed or worn, replace immediately. Contact your
dealer for approved replacement parts. Refer to replacement parts list in this manual.
The following steps should be followed for glass gasket replacement:
1.
Ensure appliance is not in operation and is thoroughly cooled
2.
Remove screws and glass clips.
3.
Lift glass out.
4.
Remove old gasket and clean glass.
5.
Replace new gasket starting at the bottom of glass working along edges, being sure to center gasket channel on glass.
6.
Trim to length and butt ends together.
7.
Replace glass in door, being sure not to over-tighten screws and clips.
The following steps should be followed for door gasket replacement:
1.
Ensure appliance is not in operation and is thoroughly cooled.
2.
Remove old door gasket and clean channel.
3.
Using an approved high temperature gasket cement, apply a thin coat in bottom of channel.
4.
Starting at hinge side of door, work into channel around door unit, end butt and trim to length.
5.
Close door and allow three to four hours for cement to set before restarting appliance.
18
Firebrick
Figure 14: Removing Firebrick
63D0001
Hide quick links:
Advertisement
Table of Contents
