Ip Group - Draytek Vigor130 User Manual

Start IP Address
End IP Address
Subnet Mask
Invert Selection
3. After finishing all the settings here, please click OK to save the configuration. Below is
an example of IP objects settings.
3 . 5 . 2 I P G r o u p
3 . 5 . 2 I P G r o u p
This page allows you to bind several IP objects into one IP group.
Available settings are explained as follows:
Item
Set to Factory Default
Type the start IP address for Single Address type.
Type the end IP address if the Range Address type is
selected.
Type the subnet mask if the Subnet Address type is
selected.
If it is checked, all the IP addresses except the ones listed
above will be applied later while it is chosen.
Description
Clear all profiles.
83 Vigor130 Series User's Guide