Table of Contents
Advertisement
USER FUNCTIONS
Scheduling User Interface
Entry
Event
0
Empty
1
X10 Device
2
Latch Key Report
3
Automatic Stay Arming
4
Reminder Announcements
5
Alarm Clock
Event Identifier Entries
No event scheduled (or schedule is temporarily disabled)
Turn an X10 device, either on or off at begin/end times. (will
have a start and end time to program) (time driven)
NOTE: SH10A siren cannot be used.
Send a special pager report (7110000) indicating system not
yet disarmed. (will have a start/end time to send the report)
(window driven), (reports only to pager)
NOTE: Option *49 must be programmed to be 6 or higher.
Make sure unit is armed prior to start of window time.
In addition a secondary phone number must be
programmed in Option *42.
Will arm the system automatically, and bypass any open
zones, at a given time. It will send a report to the pager and
central station, indicating system has been auto armed stay,
plus all bypass reports. (will have only a start time to send the
report) (time driven)
NOTES: (1) Prior executing auto stay arming, force bypass
will be executed - if option *23 was enabled.
(2) If pager report is required, Option *49 must be
programmed to be 6 or higher.
Will announce the message recorded by your installer. This
will be repeated every minute until a key is depressed, or a
button type zone does an arm or disarm.
NOTE: Make sure installer programmed the message at the
time of installation.
Will start a trouble tone (beep) on the speaker, which will
continue until a key is depressed.
Figure 1.
– 34 –
Comment
†
†
Advertisement
Table of Contents
