Assembly - Delta 36-850 Instruction Manual

ASSEMBLY TOOLS REQUIRED
ASSEMBLY TIME ESTIMATE
Approximately 2-4 hours
ATTACHING THE TABLE MOUNTING BRACKET
Refer to Figs. 10, 11 and 12 when you mount the feeder assembly to a table saw, jointer or shaper. To mount the feed-
er assembly:
1. Position the mounting bracket (A) Fig. 2 at the
desired location on the machine.
2. Mark the locations (B) where the four mounting
holes are to be drilled in the table.Three are shown
here.
3. Center punch and drill four 3/8" diameter holes at
the locations marked in STEP 2.
NOTE: DO NOT drill through any table ribs or table
supports.
4. Fasten the mounting bracket (A) Fig. 2 to the table
by inserting four 2" bolts with a flat washer through
the holes in the mounting bracket, three of which are
shown at (B) Fig. 2. Secure the bolts from under-
neath with another flat washer, a lockwasher, and a
hex nut.
ATTACHING THE SUPPORT ASSEMBLY TO THE STOCK FEEDER
1. Loosen the locking lever (C) Fig. 3, and insert the
vertical arm (D) of the support assembly into the
mounting bracket (A).
2. Tighten the locking lever (C) Fig. 3 to hold the feed-
er assembly in position on the table.
3. Insert two 3-1/2" screws (supplied) through the two
handles (E) Fig. 3. Thread the jam nuts on the ends
of the screws.
4. Position the two handles (E) Fig. 3 over the thread-
ed holes in the two handwheels (F) and thread the
handles into the handwheels.
5. Loosen the screw (G) Fig. 3, and position the end
bracket (H) over the end of the horizontal support
arm (J). Tighten the screw (G).
6. Attach the angle bracket (L) Fig. 3 on the feeder (M).
Tighten the locking lever (N).
7. Attach the feeder (M) Fig. 3 with the angle bracket
(L) on the end bracket (H). Tighten the locking lever
(P).
NOTE: You can make adjustments to the feeder mount-
ing positions later.

ASSEMBLY

3/8" Wrench
5/16" Wrench
7/16" Wrench 4mm Hex Wrench
1/2" Wrench Phillips Screwdriver
B
E
F
D
C
A
Fig. 3
8
A
Fig. 2
J P
G A
H
M
L