Operating Controls - Delta 36-850 Instruction Manual

MACHINE USE
MOTOR CONTROL SPEED SWITCH
To operate the feeder in a forward position, turn switch
(A) Fig. 7 clockwise. To operate the feeder in the oppo-
site direction, turn switch (A) counterclockwise.

OPERATING CONTROLS

Disconnect machine from power source!
1. You can rotate the entire feeder assembly (A) Fig. 8
360 degrees in the mounting bracket (B) by loosen-
ing the locking lever (C).
2. To raise or lower the feeder assembly (A) Fig. 8,
loosen the locking lever (D) and rotate the hand-
wheel (E).
3. To move the feeder assembly (A) Fig. 8 in or out,
loosen the locking lever (G) and rotate the hand-
wheel (H).
4. To adjust the position of the feeder (F) Fig. 8, loosen
the locking levers (K) and/or (L).
5. Tighten all locking levers after adjustments are com-
pleted.
FEED ROLLER REPLACEMENT
Disconnect machine from power source!
You can remove each feed roller (A) Fig. 9 to repair or re-
place by removing the two screws (B) inset, then remov-
ing the feed roller. Install the new or repaired feed rollers
and secure with the two screws (B).
LUBRICATION
Disconnect machine from power source!
Lubricate the feed rollers approximately every 200 hours
of use with grease through the grease fittings (A) Fig. 9
using the grease gun supplied with the machine.
Periodically, coat the gear chains with light machine oil.
Change the gear oil after every 1000 hours of use or
after heavy extended use. Replace the old oil with #90
weight gear oil. To gain access to the gear oil chamber,
turn the oil cap (C) Fig. 9 counter-clockwise. The oil level
should consistently be 2" to 2-1/4" below the top of the
gear case.
E
A
D
C
B
B
C
10
A
Fig. 7
A K
L
F
Fig. 8
A
Fig. 9