Presetting Stations Manually; Presetting Stations Automatically; Tuning To Preset Stations; Other Useful Features - Alpine iXA-W404E Owner's Manual

Presetting Stations Manually

1
Tune in a desired radio station you wish to store in
the preset memory by manual or automatic seek
tuning.
2
Touch [PRESET] to display the list screen of preset
stations.
3
Touch and hold any one of the preset stations
(1 through 6) for at least 2 seconds.
The selected station is stored.
4
Repeat the procedure to store up to 5 other stations
onto the same band.
To use this procedure for other bands, simply select the
desired band and repeat the procedure.
A total of 18 stations can be stored in the preset memory
(6 stations for each band; FM1, FM2 or AM).
• Touch [ ] to cancel the list screen of preset stations.
• If a preset memory has already been set in the same preset number, it
will be cleared and the new station will be memorized.

Presetting Stations Automatically

The tuner can automatically seek and store 6 strong stations in the
selected band in order of signal strength.
After selecting the desired band, touch and hold
[A.MEMO] for at least 2 seconds.
The tuner automatically seeks and stores 6 strong stations into
preset station 1 to 6 in order of signal strength.
When the automatic storing has been completed, the tuner goes
to the station stored in preset location No.1.
• The operation can also be performed by pressing and holding
/ /TUNE/A. ME button for at least 2 seconds.
• If no stations are stored, the tuner will return to the original station
you were listening to before the automatic storing procedure began.

Tuning to Preset Stations

You can tune in the preset stations in memory on each band using the
preset number.
1
After selecting the desired band, touch [PRESET] to
display the list screen of preset stations.
2
Touch any one of the preset stations (1 through 6)
that has your desired radio station in memory.
The preset station is received.
• Touch [ ] to cancel the list screen of preset stations.
Other Useful
Features

Adjusting the Audio

1
Press and hold SETUP for at least 2 seconds.
The SETUP selection screen is displayed.
2
Touch [ ] of Audio Setup.
The AUDIO SETUP screen appears.
Display example for AUDIO SETUP Screen
• Touching [ ] or [ ] will scroll the list one line at a time.
• Touch [ ] to return to the previous list screen.
• Touch and hold [ ] for at least 2 seconds to return to the main
source screen that was displayed before the setup operation was
started.
• The A.Processor menu items will differ depending on which optional
audio processor is connected. The IMPRINT audio processor
(PXA-H100) or External Audio processors may be used. For details,
refer to "IMPRINT Operation (Optional)" (page 29) or "External
Audio Processor (Optional)" (page 23).
• The AUDIO SETUP screen can also be activated directly by pressing
SOUND/IMPRINT.
Adjusting Balance/Fader
Touch [ ] of Balance/Fader, the adjusting screen of
Balance/Fader will be displayed.
Display example for BALANCE/FADER Screen
A Adjusting the Fader
Touch [F] or [R] to adjust the volume of the front and
rear speakers.
Setting range: F15 to R15
• If an IMPRINT audio processor (PXA-H100) is connected to this unit
and you have set the 2.2ch (3WAY)/4.2ch (FRONT/REAR/SUBW.)
switch of the IMPRINT audio processor (PXA-H100) to 2.2ch
(3WAY), you cannot adjust the FADER mode. For details, refer to the
Owner's Manual of PXA-H100.
11
-EN