Assembling Blade Guard And Splitter Assembly - Delta 36-477 Instruction Manual

2. Fig. 27, illustrates the motor cord connected to the
switch assembly.
ASSEMBLING
BLADE GUARD AND
SPLITTER ASSEMBLY
WARNING: MAKE CERTAIN THE SAW IS DISCON-
NECTED FROM THE POWER SOURCE.
1. Fasten the rear splitter mounting bracket (A) Fig. 28,
to the rear trunnion using the two 3/4 hex head screws
(B) and flat washers. Do not completely tighten the two
screws (B) at this time.
2. With wrenches supplied, remove the saw blade from
the saw. Refer to section "CHANGING THE SAW BLADE"
of this manual. Raise saw arbor to its highest position.
3. Remove screw and large washer (C) Fig. 29, from
the inside splitter mounting bracket.
4. Using a straight edge, check to see if the top and
bottom of the inside splitter bracket (D) Fig. 30, is
aligned with the inner arbor flange (E), as shown.
C
14
Fig. 27
A
B
Fig. 28
Fig. 29
D
E
Fig. 30