Delta ShopMaster DP115 Instruction Manual page 8

5. Thread the three pinion shaft handles (H) Fig. 8, into
the three holes located in the pinion shaft (J) as shown.
6. IMPORTANT: Make certain the spindle taper (K) Fig.
9, and tapered hole in chuck (L) are clean and free of any
grease, lacquer or rust preventive coatings. NOTE:
Household oven cleaner can effectively remove any sub-
stance from the spindle and chuck; however, carefully
follow the manufacturer's safety rules concerning its
use.
7. IMPORTANT: Open the chuck jaws as wide as
possible by turning the chuck sleeve (M) Fig. 10.
8. Holding chuck on taper of spindle, tap with a soft tip
hammer (N) or a block of wood and hammer to set
chuck, as shown in Fig. 10. IMPORTANT: To avoid
damage to the chuck, NEVER drive the chuck onto the
spindle with a metal hammer.
H
J
K
L
M
8
H
Fig. 8
Fig. 9
M
N
Fig. 10