Maintenance Changing The Blade - Delta Sidekick 36-235 Instruction Manual

W ARNING: USE O N LY CROSS-CUTTING S AW BLADES.
GULLETS A S THEY C A N DEFLECT A N D C O N TA C T GUARD.
1 . Use only 12
2 . DISCONNECT T HE MACHINE F R O M T H E P O W E R S O U R C E.
3 . Loosen screw (A) Fig. 53, with wrench (B) provided.
4 . Rotate arbor cover (C) Fig. 54, and lower guard (D)
t o t h e r e a r, exposing arbor screw (E), as shown.
5 . Remove arbor screw (E) Fig. 54, by turning screw
clockwise with wrench supplied while at the same time
pressing in on arbor lock (F) Fig. 56, to keep the arbor
from turning. Remove outside blade flange (G) F i g . 5 4 ,
and saw blade (H). D O N O T R E M O V E INSIDE B L A D E
FLANGE.
6 . W ARNING: I F T H E INNER B L A D E F L A N G E (H)
FIG. 55, HAPPENS TO B E REMOVED, IT M U S T B E
P L A C E D O N T H E A R B O R S H A F T S O T H E RAISED
B U S H I N G ( I ) POINTS A W AY F R O M M O TO R,A N D
M A K E S U R E F L AT S O N INNER B L A D E F L A N G E
A R E E N G A G E D WITH FLATS O N A R B O R SHAFT.
7 . Assemble the new saw blade MAKING C E R TAIN
T E E T H O F S AW B L A D E A R E POINTING D O W N AT
T HE F R O N T, A S S H O W N and assemble outside blade
flange (G) Fig. 54, making sure flats on outside blade
flange are engaged with flats on arbor shaft .
8 . Thread arbor screw (E) Fig. 54, into saw arbor by
turning screw (E) counterclockwise as far as possible by
hand. Then tighten arbor screw (E) with wrench supplied
while at the same time pressing in on arbor lock (F)
Fig. 55, to keep arbor from turning.
9 . Rotate arbor cover (C) Fig. 54, and lower guard (D)
to the front and tighten screw (A) that was loosened in
STEP 3 .
MAINTENANCE
CHANGING THE BLADE
diameter blades with 1
H
Fig. 55
DO N O T U S E B L A D E S WITH D E E P
arbor holes that are rated for 4800 RPM or higher.
D
C
I
26
B
A
Fig. 53
E
G
Fig. 54
F
Fig. 56
H