Table of Contents
Advertisement
Vax VCU-02 User Guide.qxd
Vax
VCU-02
To Replace New Belt
Slip brush bar through belt. Place belt in area of brush bar
without bristles (Fig.6/4).
Fig.6/4
Loop belt around motor shaft (Fig.6/5).
Fig.6/5
With new belt in place, pull and slide brushroll into nozzle
making sure that the brush bar end caps are in the correct
orientation (Fig.6/6). Rotate brushroll manually to make sure
belt is properly aligned.
Fig.6/6
8
belt & brush bar & replacement
6/3/07
13:58
MOTOR SHAFT
Page 8
Fig.6/7
To reassemble the nozzle guard, align the three (3) tabs on
the front of the nozzle guard with the slots in the base.
Rotate/pivot the nozzle guard back into position making sure
that the tab is fully engaged back by the rear wheel.
Fig.6/8
Replace the two (2) screws to secure nozzle guard.
Advertisement
Table of Contents
