IMPORTANT SAFETY INSTRUTIONS READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER WARNING_ To reduce the risk of fire, electric shock, or injury: 1. Do not leave vacuum cleaner when plugged in. Unplug from outlet when not in use and before cleaning or servicing. 2.
PRECAUTIONARY MEASURES If the opening that sucks in the air, the suction pipe or the telescopic wand stick on pipe are blocked, you should switch off the vacuum cleaner at once. First clear the blocked substance before you attempt to start the vacuum cleaner again 1.
4. When you want to pull the plug from the wall contact, please do this at the plug itself and not by means of the electrical cable. This vacuum cleaner is equipped with a plug and a cable which rolls up automatically.If anything gets damaged, both the plug and the cable must be repaired by a qualified repairman or electrician.
Page 5
b. Fitting the extension tubes c. Fitting the brush to the extension tube. Extension Tube Floor Brush d. Fitting Floor brush Ideal for the daily cleaning on carpets and hard floors. Clean on the carpet...
Clean on the hard floor 2. Cleaning tools use The crevice tool and dusting brush are stored on the accessories holder. 1.Crevice tool: For radiators, crevices, corners, baseboards and between cushions. 2.Dusting brush, only in addition with crevice tool: For the furniture, venation, blinds, book, lamp shades and shelves. INSTRUCTIONS FOR USE Before using appliance, unwind a sufficient length of cable and insert the plug into the power socket.
2. To rewind the power cable, press the rewind button with one hand and guide the cable with the other hand to ensure that it does not whip causing damage. MAINTENANCE 1. Changing of the dust bag Always operate the cleaner with dust bag installed. If you forget to attach the dust bag or attach it in the wrong manner, the dust cover may not close completely.
Page 8
1. After removing the flexible tube, open the front cover . 2. Rotate the support of the bag to the correct position. 3. Remove the dust bag from the Bag Support. 4. Replace the paper bag when it is full of dirt and put in a new one. 5.
Page 9
3.Cleaning and changing filter Filter for air-inlet should be cleaned at least twice a year or when it becomes visible solid. Always operate the cleaner with filter installed. Otherwise, reduced suction or motor damage may be result. Disconnect from electrical outlet, before cleaning filter. Do not use a washing machine to rinse filter.
③ Take the HEPA out and change a clean one. ④ Close the front cover. 3.Cleaning HEPA Rinse HAPE in lukewarm water and dry HEPA completely. Technical Specifications VC-H4510 VC-HT4510 Type Rated load (V) Rated frequency(Hz) Rated input power(W) 2000 2000 Maximal vacuum(Kpa)...