Code Approval - MHSC KHLDV400 Installation And Operating Instructions Manual

KHLDV Series Gas Fireplace
12. Do not use this fireplace to cook food or burn paper or
other objects.
13. Never place anything on top of fireplace.
14. Do not use any solid fuels (wood, coal, paper, card-
board, etc.) in this fireplace. Use only the gas type
indicated on rating plate.
15. This appliance, when installed, must be electrically
grounded in accordance with local codes or in the
absence of local codes, with the National Electrical
Code, ANSI/NFPA 70, or the Canadian Electrical Code,
CSA C22.1.
16. Do not obstruct the flow of combustion and ventilation
air in any way. Provide adequate clearances around
air openings into the combustion chamber along with
adequate accessibility clearance for servicing and
proper operation.
17. When the appliance is installed directly on carpeting,
tile or other combustible material other than wood floor-
ing, you must set appliance on a metal or wood panel
or hearth pad extending the full width and depth of the
appliance.
18. Do not use fireplace if any part has been exposed to
or has been under water. Immediately call a qualified
service technician to inspect the appliance and replace
any part of the control system and any gas control which
as been submerged in water.
19. Do not operate fireplace if any log is broken.
20. Do not use a blower insert, heat exchanger insert, or
any other accessory not approved for use with this
fireplace.
21. Do not operate the fireplace with glass door removed,
cracked, or broken.

coDe approVaL

Direct Vent type appliances draw all combustion air from
outside of the dwelling through the vent pipe.
These appliances have been tested by CSA and found to
comply with the established standards for DIRECT VENT
GAS FIREPLACE HEATERS in the USA and Canada as
follows:
LISteD VenteD GaS FIrepLace Heater
TESTED TO: ANSI Z21.88-2009 / CSA 2.33-2009
STANDARDS
A manufactured home (USA only) or mobile home OEM
installation must conform with the Manufactured Home
Construction and Safety Standard, title 24 cFr, part
3280, or when such a standard is not applicable, the
Standard for Manufactured Home Installations, anSI/
ncSBcS a225.1, or Standard for Gas equipped recre-
ational Vehicles and Mobile Housing, cSa Z240.4.
4
IMportant SaFety InForMatIon and coDe approVaL
It is normal for fireplaces fabricated of steel to give off
some expansion and/or contraction noises during the
start up or cool down cycle. Similar noises are found with
your furnace heat exchanger or car engine.
It is not unusual for gas fireplaces to give off some odor
the first time it is burned. This is due to the manufacturing
process.
please ensure that your room is well ventilated
It is recommended that you burn your fireplace for at
least ten (10) hours the first time you use it. Place the
fan switch in the "OFF" position during this time.
IMportant:
pLeaSe reaD tHe FoLLowInG
careFuLLy
IMportant:
pLeaSe reaD tHe FoLLowInG
careFuLLy
during burn off — open all windows.
never connect unit to private (non-
utility) gas wells. this gas is commonly
known as wellhead gas.
WARNING
!
DO NOT TOUCH GLASS
NEVER ALLOW CHILDREN
AVERTISSEMENT
!
Un panneau vitré chaud peut
Laissez refroidir le panneau
vitré avant d'y toucher.
Ne laisser jamais les enfants
toucher le panneau vitré.
HOT GLASS WILL
CAUSE BURNS.
UNTIL COOLED.
TO TOUCH GLASS.
causer des brûlures.
73D0024