Code Approval - MHSC 400DVBLNV7CE Installation And Operating Instructions Manual

DVBL7 Series Gas Fireplace
13. Do not use any solid fuels (wood, coal, paper, card-
board, etc.) in this fireplace. Use only the gas type
indicated on rating plate.
14. This appliance, when installed, must be electrically
grounded in accordance with local codes or in the
absence of local codes, with the National Electrical
Code, ANSI/NFPA 70, or the Canadian Electrical Code,
CSA C22.1.
15. Do not obstruct the flow of combustion and ventilation
air in any way. Provide adequate clearances around
air openings into the combustion chamber along with
adequate accessibility clearance for servicing and
proper operation.
16. When the appliance is installed directly on carpeting,
tile or other combustible material other than wood floor-
ing, you must set appliance on a metal or wood panel
or hearth pad extending the full width and depth of the
appliance.
17. Do not use fireplace if any part has been exposed to
or has been under water. Immediately call a qualified
service technician to inspect the appliance and replace
any part of the control system and any gas control which
as been submerged in water.
18. Do not operate fireplace if any log is broken.
19. Do not use a blower insert, heat exchanger insert, or
any other accessory not approved for use with this
fireplace.
20. Do not operate the fireplace with glass door removed,
cracked, or broken.

coDe approVaL

Direct Vent type appliances draw all combustion air from outside of the dwelling through the
vent pipe.
These appliances have been tested and found to comply with the established standards for DIRECT
VENT GAS FIREPLACE HEATERS:
4
IMportant SaFety InForMatIon & coDe approVaL
LISteD VenteD GaS FIrepLace heater
IMportant:
pLeaSe reaD the FoLLowInG careFuLLy
It is normal for fireplaces fabricated of steel
to give off some expansion and/or contraction
noises during the start up or cool down cycle.
Similar noises are found with your furnace heat
exchanger or car engine.
IMportant:
pLeaSe reaD the FoLLowInG careFuLLy
It is not unusual for gas fireplace to give off some
odor the first time it is burned. This is due to the
manufacturing process.
please ensure that your room is well
ventilated during burn off — open all
windows.
It is recommended that you burn your fireplace
for at least ten (10) hours the first time you use it.
Place the fan switch in the "OFF" position during
this time.
never connect unit to private (non-utility)
gas wells. this gas is commonly known
as wellhead gas.
20301763