Amana AM26LP-P Use & Care Manual page 7

Assemble grill head to cart base
Excessive Weight Hazard
Use two or more people to move and install grill.
Failure to do so can result in back or other injury.
1.
Tilt the Grill head assembly onto back with control panel facing up.
2.
Remove tape holding gas pressure regulator/hose assembly from
underside of the grill and remove package material. Pull the gas
pressure regulator/hose out through the opening in the right side
of the grill head.
3.
Use (8) M5 x 10 Phillips pan head screws to attach the 4 support
poles onto connecting bracket of the Grill head.
NOTE: DO NOT completely install the screws just partially
tighten them until all poles are in place.
D
A
.
A. Connecting bracket
B. Support poles - left
C. Support poles - right
D. M5 x 10 Phillips pan head screws
4.
Use the bolt, wheel, washer and the lock pin to secure the wheel
to the support pole left front as shown.
5.
Then repeat this to secure the other wheel to the support pole left
back as shown.
A. Bolt
B. Wheel
C. Washer
D. Lock Pin
C
B
A
B
C
D
6.
Use (4) M6 x 10 Phillips pan head screws to secure the Grill cart
base to the support poles as shown.
Note: Add flat washer and lock washer then install the screws
in position.
A. Grill cart base
B. M6 x 10 Phillips pan head screws
7.
Have someone help you to stand the grill upright.
8.
Slide the side shelf left and side burner right in position as shown.
9.
Use (8) M5 x 40 Phillips pan head screws to secure the side shelf
left and side burner right as shown.
10.
Fasten (8) M5 x 10 Phillips pan head screws to secure the
(4) support poles onto connecting bracket.
A
C
A. Side shelf - left
B. Side burner shelf - right
C. M5 x 40 Phillips pan head screws
11.
Use (6) self-tapping screws to secure the front panel in position
as shown. The decorative slots should be on the right side when
facing the front of the grill.
A
A. Front panel
B. Self-tapping screws
.
A
B
B
B
7