Yamaha XMV4280 Owner's Manual page 13

@1 Dante [PRIMARY]/[SECONDARY] connectors
(XMV4280-D/XMV4140-D only)
These are RJ-45 connectors that allow the unit to be con-
nected to another Dante device such as the MTX5-D via an
Ethernet cable. The Dante [PRIMARY] connector can also
be used to connect to a computer via an Ethernet cable. To
connect, refer to the "MTX Editor User's Manual."
NOTE
• Use a CAT5e or better STP (Shielded Twisted Pair) cable
for the connection to the Dante [PRIMARY]/[SECOND-
ARY] connectors to prevent electromagnetic interference.
Make sure that the metal parts of the plugs are electrically
connected to the STP cable shield by conductive tape or
comparable means.
• Connect only Dante-compatible devices or GbE-compati-
ble devices (including a computer).
• Since Dante-compatible equipment made by Yamaha
such as the XMV4280-D/XMV4140-D contains a built'-in
network switch, the number of hops will be two or more.
For this reason, the 0.15 msec Latency setting in Dante
Controller will be grayed-out and unavailable.
@2 [UNIT ID] rotary switch
If multiple devices such as XMVs or MTXs are connected
on the same network, this rotary switch enables you to spec-
ify the UNIT ID that identifies each unit individually.
XMV4280/XMV4140
With the combination of the device setup DIP switches
1–3 @3 for upper digits and the rotary switch for lower dig-
its, the UNIT ID can be specified in a maximum of 127
values, from "01" to "7F."
XMV4280-D/XMV4140-D
With the rotary switch (HIGH) used for upper digits and
the rotary switch (LOW) for lower digits, the UNIT ID can
be specified in a maximum of 254 values, from "01" to
"FE."
NOTE
• Do not use "00" or "FF" as the UNIT ID.
• After you set the [UNIT ID] rotary switch, turn the power to
the unit off and then on.
@3 Device setup DIP switch
This DIP switch is used to make settings for the XMV. Refer
to the following for details on the settings.
NOTE
To change the switch settings, turn off the power to the unit.
If you change the settings while the power is on, the change
will not be effective until you turn the unit off and then on.
Refer to the following for details.
Switch
Indicates the switch is in the upward posi-
tion.
Indicates the switch is in the downward posi-
tion.
XMV4280/XMV4140
1 2 3
XMV4280-D/XMV4140-D
1 2 3
NOTE
Switch 1 and 2 are not used for the XMV4280-D/XMV4140-
D. Use the swiches in the factory set state (upward).
XMV4280/XMV4140/XMV4280-D/XMV4140-D Owner's Manual
Controls and Functions
Status
4 5 6 7 8
4 5 6 7 8
13