Changing The Remote Private Network Password - NetComm NP508 User Manual

Note: In case you cannot connect into the network after changing the Private Network Password, please power cycle the device. To
power cycle, disconnect and then reconnect the Powerline adapter from the power outlet.

Changing the Remote Private Network Password

Without leaving your computer, you can change the Private Network Password of remote Powerline devices, provided they are
using the same Private Network Password as your local Powerline adapter. You cannot change the Private Network Password of
remote devices that is not currently networked with your local Powerline adapter.
Note: When changing the Private Network Password of remote devices, you will need the Device ID that appears on the label
pasted on the device. It is a good idea to list the Device ID of all your Powerline adapters to enable you to remotely change their
settings using the Powerline Web User Interface.
To change the Private Network Password of a remote Powerline adapter:
1. Open the Web User Interface, Under Network Tab, Powerline Settings
2. Go to Remote Device Configuration.
3. Enable Security
4. Type the Device Name (If any).
5. Enter the MAC Address of the other remote Powerline adapter.
6. Enter the Device Password. The Device Password can be found on the label on each respective device.
7. Click Save. When the process is complete, the message "Settings Applied" appears.
After changing the Private Network Password of the remote Powerline adapter, it will no longer be able to communicate
with your local Powerline adapter, unless you use the same Private Network Password for your local Powerline adapter.
www.netcommwireless.com NP508 – 500Mbps Powerline Adapters User Guide
21