NetComm POWERLINE NP504 Quick Start Manual

NetComm POWERLINE NP504 Quick Start Manual

Powerline series 500mbps powerline adapters with ac pass-through
Hide thumbs Also See for POWERLINE NP504:

Advertisement

NETCOMM POWERLINE™ SERIES
500Mbps Powerline Adapters
with AC Pass-through
NP504 Quick Start Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the POWERLINE NP504 and is the answer not in the manual?

Questions and answers

Summary of Contents for NetComm POWERLINE NP504

  • Page 1 NETCOMM POWERLINE™ SERIES 500Mbps Powerline Adapters with AC Pass-through NP504 Quick Start Guide...
  • Page 2 Setting Up Your Powerline Adapters Using one of the supplied Ethernet cables connect one end into the LAN Ethernet port of your modem/router. Connect the other end of the same cable into one of the Powerline Adapters. Connect the Powerline Adapter to a power point near your modem/router.* *NOTE: For best performance plug your Powerline Adapters directly into the wall.
  • Page 3 Connect one end of the other supplied Ethernet cable into the Ethernet port of any device you want to connect to the Internet (PC, set-top box, gaming console, PVR, blu-ray player etc). Connect the other end of the cable into the second Powerline Adapter. Connect the Powerline Adapter to a power point near your device.
  • Page 4 At this point, you can plug another electrical appliance into the Powerline Adapters AC pass-through if you wish to do so. Both Adapters will take a short time to find each other. Once they have, all three lights on both Adapters should be on. NOTE: For best performance connect other electrical devices to the AC Pass-through socket rather than connecting the Powerline Adapter to a powerboard.
  • Page 5: Troubleshooting

    Troubleshooting For any technical support enquiries please contact the NetComm technical support team on WWW.NETCOMM.COM.AU/CONTACT-US to fill out an online enquiry or alternatively call (02)9424 2059 What can the LEDs tell me? The powerline LED changes colour depending on the speed of your data transfer.
  • Page 6 My Powerline Adapters Will Not Connect To Each Other Hold down the Simple Connect button on the first device for 15 seconds, or until the LEDs flash, then hold the Simple Connect on the second device for 3 seconds and finally hold the Simple Connect button on the first device for 3 seconds. The network password has now been reset and both adapters will be able to communicate with each other.

Table of Contents