Table of Contents
Advertisement
5.CHOOSING THE POWER SOURCES
You ca use the AC power or batteries as a power source.
5.1 Connecting the AC power cord
Insert one end of the supplied AC power cord into the socket located at the rear of the
player,and the other end to the wall outlet.
5.2 Connecting to USB storage
1
）
P lease connect the USB storage to the USB terminal of the main unit
2) The main unit will read the contents that are available on the USB storage device
automatically.
Note:
(1) When disc play, then insert the USB, the unit will automatically switch to play USB .
(2) When USB play, then place the disc, the unit will automatically switch to play the disc.
(3) When the existence of USB and the disc, the unit will play USB at first.
5.3 Using the player on batteries
Insert 6 size"C"batteries (not supplied) into the battery compartment.
To use the player on batteries, disconnect and remove the AC power cord both from back
of the player and the wall outlet.
Note:
If the plug of the AC power cord does not match your outlet,do not force it. Reverse it
·
and try again.The plug is polarized and only fits one way into the wall outlet and rear of the
set.
R eplace the batteries when the POWER lamp dims or when the player stops operating.
·
Replace all the batteries with new ones.Before you replace the batteries,be sure to take
out the CD from the player.
I f the CD does not play on batteries, this means the batteries are almost used up.But the
·
radio may continue to play on these weak batteries because it uses less power than the
CD player.
6.PLAYING A CD or MP3
(1) Connect the supplied AC power cord or batteries.
(2) Slide the FUNCTION switch to CD/USB/AUX IN position
(3) Open the CD door and place a disc in the CD compartment with the label side up.
(4) Close the CD door, the unit will play the disc.
(5) Press the PLAY/PAUSE button in play mode to pause the playback.Press the
PLAY/PAUSE button again to resume the playback.
(6) Adjust the VOLUME control to your preference.
(7) Press the STOP button to stop the playback.
(8) Slide the FUNCTION switch to OFF position to turn off the power.
NOTE:
"
" will show in the display if there is no disc in the CD compartment or if the disc is
- - -
upside down.
Advertisement
Table of Contents
