J-300
8. Place Cover On Spa
•
Keeping the insulating cover in place anytime the spa is not in
use will reduce the time required for heating, thereby minimizing
operating costs.
•
The time required for initial heat-up will vary depending on the
starting water temperature.
DANGER:
!
Check water temperature carefully before entering hot tub!
Excessive water temperature can cause burns, welts and body
temperature to rise, hyperthermia (over-heating).
Decontamination Procedure (Steps 9-16)
Steps 9-16 below are only required when sanitizer levels are unstable
after performing steps 1-6 above. Disregard steps 9-15 below if sanitizer
levels remain stable after performing steps 1-6 above (refer to the inside
cover of the manual).
9. Add 2.5 ounces (71 g) of sodium dichlor for every 100 gallons (378
Liters) of water. Refer to the table below for approximate water fill
volume by model.
CAUTION: RISK OF PERSONAL INJURY OR SPA DAMAGE!
!
Never add chlorine tablets (trichlor) or acid to your hot tub for
any reason! These chemicals may damage components within
your hot tub, burn or irritate your skin, create a rash, and void
the manufacturer warranty for your spa.
Water Fill Volume by Model
Spa Model
J-375
J-365
J-355
J-345
J-335
J-325
J-315
*Use average fill volume for chemical maintenance
20
RISK OF PERSONAL INJURY.
Average Fill Volume*
415 Gal (1,571 L)
400 Gal (1,514 L)
390 Gal (1,476 L)
340 Gal (1,287 L)
330 Gal (1,249 L)
325 Gal (1,230 L)
210 Gal (795 L)
Sodium Dichlor
10.5 oz
10.0 oz
10.0 oz
8.5 oz
8.0 oz
8.0 oz
5.0 oz