Table of Contents
Advertisement
2.
Push the knob down for 10 seconds and turn it
counterclockwise to the maximum position
3.
Keep the knob pushed for approximately 10 sec-
onds. This will let thermocouple warm up. If not, the
gas supply is interrupted.
4.
Adjust the flame when it is regular.
If after some tries the burner does not light, check if
the crown and its cap are in the correct positions.
Burner cap
1
Burner crown
2
Thermocouple
3
Hob - Helpful hints and tips
Energy savings
• If possible, always put the lids on the pans.
• When the liquid starts to boil, turn down the flame to
barely simmer the liquid.
Use pots and pans with bottom applicable to the di-
mension of the burner.
Burner
Rapid
Hob - Care and cleaning
Warning! Refer to "Safety information" chapter.
6
.
1
2
3
Diameters of cookware
160 mm - 240 mm
Warning! Do not keep the control knob pushed for
more than 15 seconds.
If the burner does not light after 15 seconds, release the
control knob, turn it into off position and try to light the
burner again after minimum 1 minute.
If the burner accidentally goes out, turn the control
knob to the off position and try to light the burner
again after minimum 1 minute.
Turning the burner off
To put the flame out, turn the knob to the symbol .
Warning! Always turn the flame down or switch it off
before you remove the pans from the burner.
Burner
Semi-rapid
Auxiliary
Use cookware with the bottom as thick and flat as possi-
ble.
Warning! Switch the appliance off and let it cool
down before you clean it.
Diameters of cookware
140 mm - 240 mm
120 mm - 180 mm
www.zanussi.com
Advertisement
Table of Contents
