Adjustments - Exmark Turf Tracer Operator's Manual

c)
Note: Do not use anti-seize compound on the wheel hub.
5.1.20 Thread locking adhesives such as "Loctite 242" or "Fel-Pro, Pro-Lock Nut-
Type" are used on the following fasteners:
a)
b)
c)
e)
f)
g)
h)
i)
Adhesives such as "Loctite RC/609 or RC/680" or "Fel-Pro Pro-Lock Retaining
I or Retaining II" are used on the following:
a) OPC lever hubs and cross-shaft
NOTE: Care must be used not to bond the bearing, next to each OPC
hub, to the cross shaft which could cause binding of the OPC levers and
erratic operation.
5.1.21 Mobil HTS grease (or food-grade antisieze) is used in the following locations:
a)
b)
c)
5.1.21 Dielectric grease is used on all blade type electrical connections to prevent
corrosion and loss of contact.

5.2 ADJUSTMENTS

IMPORTANT: Disengage PTO, shut off engine, wait for all moving parts to stop,
and remove key before servicing, cleaning, or making adjustments to the unit.
5.2.1 Cutting height and anti-scalp roller adjustment.
POTENTIAL HAZARD
♦ When mower deck is not installed or the two front
support rod hairpins are removed, the unbalanced
weight of the tractor or tractor with mounted mower
deck support frame may cause the front of the unit to
rise suddenly.
WHAT CAN HAPPEN
♦ If the unit rises suddenly, injury may occur.
HOW TO AVOID THE HAZARD
♦ Securely hold down the front end of the unit when the
mower deck is not installed or front support rod
hairpins are removed.
a)
b)
IMPORTANT: To maintain correct cutting height and rake, check the
following for proper adjustment.
Replace cotter pin.
Pump drive sheave setscrews.
Square head setscrews on Hydro pump control arms.
Shoulder bolts in ends of speed control crank.
OPC lever setscrews.
Electric clutch retaining bolt.
Pump drive idler pivot bolt.
Fuel tank bulkhead fitting threads.
Thumblatch screw threads on handles.
Between the cutter housing spindle and bearings.
Between the cutter housing spindle and sheave.
Under top cutter housing bearing guard.
CAUTION
Stop engine and wait for all moving parts to stop.
Install hairpin clips in the holes for the desired cutting height. See Figure 8.
- 27 -