Exmark Turf Tracer Operator's Manual page 33

1. The front and rear hairpins are in the same holes with the proper spacers
under the hair pins. See Figure 7.
2. The tire pressures are set as directed in Section 5.1.12.
3. The length of the rear deck support link assemblies are should average
6.89" (approximately 6 7/8" (17.5 cm)) from the center of the balljoint to
the center of the farthest hole. See Figure 7.
NOTE: All (4) pins must equally support the weight of the deck.
Adjustment in the length of the rear deck support assemblies may be
necessary. If one side is longer than 6.89" (17.5 cm), than the opposite
side must be shorter by the same amount.
LEFT HAND
SIDE SHOWN
CUTTING HEIGHT ADJUSTMENT
ANTI-SCALP ROLLER BOLT INSTALLATION
ANTI-SCALP ROLLER AND
CUTTING HEIGHT ADJUSTMENT
c) Adjust anti-scalp rollers for Normal Operating Conditions. Place rollers in one
of the positions shown in Figure 8. Rollers will maintain 3/4 in. (19 mm)
clearance to the ground to minimize gouging and roller wear or damage.
For Maximum Deck Flotation, place rollers one hole position lower.
Rollers should maintain 1/4 in. (6.4 mm) clearance to ground. Do Not
adjust rollers to support the deck. Be sure roller bolts and nuts are
installed with the spring disc washer between head of the bolt and
mounting bracket.
Torque to 40-45 ft-lbs. (54-61 N-m), or loss of roller may result.
FIGURE 7
FOR CUTTING HEIGHTS ABOVE
3.5" (8.89 CM) USE THE BOTTOM HOLE
THE ROLLERS WILL STILL BE
EFFECTIVE AGAINST SCALPING
FIGURE 8
- 28 -