Fujitsu PRIMERGY BX620 S5 Operating Manual page 41

Installation and operation
1 Power/idle indicator (bicolor LED)
Dark:
Lights up
green:
Lights up
orange:
Flashes
green:
Flashes
orange:
Flashes
green-orange
Flashes
green-dark-
orange
2 On/Off button Fully compatible with the Advanced Configuration
Power Interface (ACPI)
If the basic unit is switched on (5 V standby voltage is present), the
server blade is switched off and you press the On button, the power_up
command is sent to the management blade and the server blade is
switched on.
If the server blade is switched on and the On/Off button is pressed for
less than 4 seconds, the power_off command is sent to the
management blade and the server blade is switched off by the
management blade (graceful shutdown).
If the server blade is switched on and the On/Off button is pressed for
longer than 4 seconds, it is switched off immediately.
BX620 S5
The basic unit is switched off, no 5 V standby voltage,
or the server blade is not installed correctly.
Server blade is switched on.
Server blade is switched off; the basic unit is switched
on (5 V standby voltage is present).
Server blade is switched on and was selected for identi-
fication, or this server blade is in a critical state.
Server blade is switched off and was selected for identi-
fication, or this server blade is in a critical state.
Server blade is in standby mode (ACPI function) or is in
a critical state.
Server blade is in standby mode (ACPI function) and
was selected for identification, or this server blade is in
a critical state.
Operating Manual
Control and connection panel
41