Exmark Turf Tracer Operator's Manual page 16

NOTE: Place spring washer cone side against bolt head (cupped side away from head)
and install to inside of engine deck (as shown in Figure 1). Install with whizlock
nuts to the outside of the support frame. Tighten until spring washers are flat.
3.3.4 Position tractor with cutter deck support frame in place, over the cutter deck.
POTENTIAL HAZARD
♦ When cutter deck is not installed or the two front
support rod hairpins are removed, the tractor or tractor
with mounted cutter support frame may cause the
front of the unit to rise suddenly.
WHAT CAN HAPPEN
♦ If the unit rises suddenly, injury may occur.
HOW TO AVOID THE HAZARD
♦ Securely hold down the front end of the unit when the
cutter deck is not installed.
Align and re-install the cutter deck support pins into the support frame. Install
the two washers and hairpins onto the front support pins and the two hairpins
and washers onto the rear support pins (See Figure 2).
3.3.5 Cutter Deck Stationary Idler Installation:
Locate the two holes along the back center section of the deck (See Figure 3)
and install the stationary idler and related parts (from bolt bag) in the right hand
hole. Be sure the coned end of the disc spring washer is against the head of
the bolt. Tighten hardware.
3.3.6 Install the deck drive belt around the clutch. Refer to belt routing decal. Be
sure belt is in the clutch drive sheave groove. Place the other end of the belt
into the V-groove of the stationary idler, move the spring loaded idler outward
and route the belt around the inside of the spring loaded idler. Position the belt
into the V-groove of the cutter deck drive sheave. Carefully release the spring
loaded idler. Install the center belt shield.
CAUTION
Fig. 2
SUPPORT PIN LOCATION
- 11 -