Shutting Down The Projector; Troubleshooting Your Setup - InFocus IN1112A User Manual

Shutting down the projector

The projector automatically displays a black screen after no active source is
detected for 30 minutes. This black screen helps preserve the life of the projector.
The image returns when an active source is detected or a remote or keypad button is
pressed.
Auto Off Time
The projector also has an Auto Off Time feature that automatically turns the
projector off after no active sources are detected and no user interaction with the
projector is performed for 30 minutes. By default, this feature is off. You can
change the length of time, see page 30.
Turning off the projector
To turn the projector off, press the Power button on the remote or keypad. The lamp
turns off and the LED blinks amber for 1 minute while the fans continue to run to
cool the lamp. When the lamp has cooled, the LED lights amber and the fans stop.
Unplug the power cable to completely power off the projector.

Troubleshooting your setup

If your image appears correctly on the screen, skip to the next section. If it does not,
troubleshoot the setup.
The Status Indicator Panel on top of the projector indicates the state of the projector
and can help you troubleshoot.
.
Table 3: Status indicator light behavior and meaning
Status Indicator Panel icons
Power, solid amber
Power, blinking green
Power, solid green
Power, blinking amber
Thermometer
Lamp
Wrench/Service
11
Meaning
The projector is plugged in.
The power button has been pressed and the
software is initializing.
The projector is on and initialized.
The power button has been pressed to turn
the projector off and the fans are running
to cool the projector.
The projector is too hot. Make sure the
vents aren't blocked (see page 17). Turn off
the projector and wait one minute, then turn
the projector on again. Visit
www.infocus.com/support to contact
service.
Turn off the projector and wait one minute,
then turn the projector on again. If the
lamp light turns on again, replace the lamp
and reset the lamp timer.
Turn off the projector and wait one minute,
then turn the projector on again. If the
service lamp turns on again, service is
required. Visit www.infocus.com/support
to contact the service department.