Lifting And Transport; Troubleshooting - Husqvarna FS 1000 E Operator's Manual

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7. Lifting and transporting the
floor saw
The FS 1000 EM floor saw has a lifting eye, which must be
used when lifting the machine. Don't lift using any other parts,
as this could cause damage to the machine and personal injury.
If using a lifting strap, attach it to the lifting eye so that the
machine cannot tip over during lifting. See figure 7.1. When
transporting the floor saw, apply the parking brake and use
anchor straps or the like to prevent it from moving about. See
figure 7.3.
Figure 7.1
1
7.1.1. Lifting eye

8. Troubleshooting

WARNING! Before attempting to fix a fault you must make
sure that the power cables are disconnected to prevent the
machine from starting up while you are working.
If there is a fault with the machine check first whether it
matches any of the faults described in the troubleshooting
chart below.
FAULT
Blade turns wrong way.
Drive belt is slipping.
Motor cuts out.
No cooling water.
Blade gets jammed.
Motor does not start.
NOTE! Do not start the machine before rectifying the cause of the fault.
CAUSE
Phases from power cable are inverted.
Belt is too slack.
Drive belt is worn.
Drive belt is oily.
Cutting depth too large.
Cutting speed too high.
Diamond segments are worn.
Blade gets jammed.
Nozzles are blocked.
Water pressure too low.
Blade is worn.
Blade gets jammed.
Electrical fault.
Emergency stop activated.
Figure 7.2
7.2. Parking brake off
Figure 7.3
7.3. Parking brake on
If you cannot localise the fault and it does not match any of the
faults described in the troubleshooting chart you should
contact your supplier for additional information.
REMEDY
Change polarity
using phase inverter.
Adjust belt tension.
Replace the drive belt.
Clean the drive belt.
Reduce cutting depth.
Advance more slowly.
Replace diamond blade.
Support floor from below
using props or a jack.
Clean nozzles.
Increase water pressure.
Replace blade.
Support floor from below
using props or a jack.
Contact your electrician.
Determine cause. When fault is
fixed, pull up emergency stop.
9