Safety Precautions; Rating Plate, Warning Signs And Their Meanings; Preparations Before Starting - Husqvarna FS 1000 E Operator's Manual

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

2. Safety precautions

You must follow the safety precautions before starting the
machine. If the user does not follow these precautions then
neither Husqvarna Construction Products Sweden AB nor its rep-
resentative can accept any liability, whether direct or indirect.
The machine must not be used by any authorised person unless
supervised by an authorised and experienced operator.
WARNING! Make sure you have read and understood the
instructions in this manual before connecting the machine to
the electrical supply.
• Check that the electrical connections are secure and that
the power cable and plug comply with the specifications.
See section 9 Technical specifications.
• Make sure that no-one comes closer than 4 metres to the
front or side of the floor saw during operation.
• Check that the blade guard and blade flange guard are
fitted correctly.
• The emergency stop must not be deactivated during start-
up or operation.
• Before you start cutting, plan your work and clearly mark
out the area you intend to cut so that you can carry out
the work without risk of injury or damage to the machine.
See figure 3.1.
• Check the building drawings to make sure there is no
concealed wiring or plumbing in the area where you are
cutting.
• Before you start cutting, make sure that any wiring in
your working area is not carrying current.
• Before you start cutting, make sure that any plumbing in
your working area has been shut off or disconnected.
• You must use the specified protective equipment and
should wear protective clothing. See following page. Do
not wear loose-fitting clothes that could catch on the
machine or its moving parts.
• Anyone who has to remain nearby during cutting must
wear hearing protection.
• Do not tilt, twist or carry the floor saw when the blade is
turning.
2.1. Warning signs and their
locations
The machine rating plate is located on the right side of the
frame, as shown below.
Machine model: FS 1000 EM
Motor rating: 11 kW
Max. drive shaft rpm: 965 rpm
Max. blade diameter: 1000 mm
Max. peripheral blade speed: 63 m/s
Weight: (excl. blade) 285 kg
Year of manufacture:
Manufacturer: Husqvarna Construction Products Sweden AB
Warning signs and their locations
The following decals on top of the frame explain that:
you should read and follow the instruction manual before
operating the floor saw you should wear safety equipment.
The emergency stop is labelled
NÖDSTOPP
A decal on top of the blade guard
shows the direction of rotation of
the blade.
Protective equipment
The following protective equipment must be
used when working with the floor saw.
Helmet, hearing protection
and eye protection

3. Preparations before starting

NOTE! Follow the safety precautions.
Do not fit a blade without first checking the direction of rota-
tion of the drive shaft.
Plan your work and mark out the area to be cut.
• Check that the power cable and polarity match the speci-
fications. See section 9 Technical specifications.
• Check that the water-cooling coupling matches the speci-
fications. See section 9 Technical specifications.
5
The control panel is labelled
You must wear safety shoes