Table of Contents
Advertisement
INSTALLATION
Remove and discard cantilever shelf packing
clips located just above each shelf where it hooks
onto the frame. To remove plastic clips, wiggIe
the clips sideways and pull straight out.
Locating
Your Refrigerator
TURN LEO CLOCKWISE TO
1. Allow a free flow of air through the front base
RAISE CABINET CORNER.
TURN LEG COUNTER-
grille.
CLOCKWISE TO LOWER
CABINET CORNER.
2. Your model should not be installed where the
room temperature wilI go below 56 degrees
F., beeanse it will not run frequently enough
to maintain proper temperature in the fi'eezei:
3. If the floor is not level and it is necessary to
raise the back of the cabinet, we suggest
3. For ease of installation, you should leave a
rolling the back wheels onto a piece of
space of about 1/2 ineh between the
plywood or other shim material.
refrigerator and adjacent walls or cabinets. If
the refrigerator is placed with the hinge side
4. To replace the base grille, center the clips in
against a wall, you may want to leave
the cut-out areas and push in until it snaps
additional space so the door can be opened
into place.
wider.
Connecting the Appliance
Important
Leveling
W_INC:
This appliance is designed to
Information
operate on a nominal 115 volt, 15 amp, 60 cycle
Your refrigerator is equipped with front and back
line. There should be a separate, grounded
rollers for ease in installation and cleaning,
circuit serving this appliance only. Do not use an
Leveling legs are also located beneath each front
extension cord.
corner to ensure the refrigerator sits firmly on
This appliance is equipped with a fllree-pronged
the floor and is level,
grounding plug for your protection against
possible electrical shock hazards. It must be
To
level
the
refrigerator:
plugged into a grounding receptacle. Where a
1. Remove the base grille by grasping the ends,
standard two-prong wall receptacle is
lift and pull out.
encountered,
it is the personal responsibility and
obligation of the customer to have it replaced
with a properly grounded three-prong wall
receptacle. Do not under any circumstances, cut
or remove the third (ground) prong from the
power cord. Do not use an adapter plug.
_
_
2. Turn the leveling leg cloe!c_viseto raise the
eabinet or counterclockwise to lower the
cabinet.
I_
PAGE 2
Advertisement
Table of Contents
