First Alert ReadyGuard Plus User Manual page 36

USER FUNCTIONS USER FUNCTIONS
USER FUNCTIONS USER FUNCTIONS
Scheduling User Interface
xxdn
Device # 1-16
Event
0 = Empty
1 = X10 Device
2 = Latch Key Report
(reports only to pager)
3 = Automatic Stay Arming
4 = Reminder
Announcements
5 = Alarm Clock
Device Number
Enter a two-digit device number (xx = device number)
Selections
01-16
[*] = Accept entry and continue
[#] = Return to previous prompt
Table 1 - Event Identifier Entries
No event scheduled (or schedule is temporarily disabled)
Turn an X10 device, either on or off at begin/end times. This is a time
driven event that requires a begin and end time.
NOTE: SH10A siren cannot be used.
A special pager report (7110000) indicating system not yet disarmed will
be sent (will have a start/end time to send the report). This is a window
driven event that requires a begin/end time.
NOTE: This option requires that certain features be programmed by your installer.
Check with your installer if you plan to schedule this event.
System will bypass any open zones and arm automatically, at a
programmed time. A report will be sent to the central station, indicating
system has been auto armed stay, along with all bypass reports. This is a
time driven event that requires a begin time to send a report.
NOTE: Prior executing auto stay arming or scheduled stay arming, force bypass
will be executed - if Forced Bypass was enabled.
System will announce the message recorded by your installer. This will be
repeated every minute until a key is depressed, or a button type zone
does an arm or disarm. This is a reminder announcement that requires a
begin day to send a report.
NOTE: Make sure installer programmed the message at the time of installation.
System will sound a trouble tone (beep) on the speaker, which will
continue until a key is depressed. This is a an alarm clock that requires a
begin day to send a report.
– 36 –
Description