Auto Storing; Squelch (Sq) Mode - Uniden UBC785XLT Owner's Manual

UB343ZH_UBC785XLT_OM_0622

Auto Storing

The scanner automatically stores active frequencies if its Auto Store feature is turned ON.
But the frequencies already stored can not be stored. To make use of this feature, set a
search range first (see page 33). If you start this feature without setting a search range, NO
LIMIT DATA appears on the display.
1. Press MENU.
2. Select 1:SERVICE OPTION / 2:CHAIN SEARCH / 7:AUTO STORE by
rotating the VFO and pressing E.
3. Select 1:ON by rotating the VFO and pressing E.
Remember! You can also use L or M instead of rotating the
VFO. Also instead of pressing E, you can press the VFO
control.
4. Select the bank number you want to store with the keypad.
The selected bank number appears on the display.
Note: If the selected bank has no free channels to store, CH
DATA FULL will appear on the display and you will
hear a beep.
6. Press SRCH to start auto storing.
7. When the selected bank has no free channel, the scanner
stop auto storing and STORE END appears. If you want to
stop auto storing on the way, press L/HOLD.

Squelch (SQ) Mode

The scanner has the following SQ modes.
• Carrier SQ mode (default setting)
The scanner will stop on any active frequencies or squelch opening, regardless of whether
any subaudible tone has been programmed on your scanner for the channel or search
range.
• Tone SQ mode
The scanner will stop on any active frequency for which you have not programmed any
subaudible tone or whose subaudible tone is the same as the one you have programmed.
• Tone Search mode
When the scanner stops on an active frequency, the scanner will begin searching the sub-
audible tone used on the frequency one of which may also be in use. The scanner counts
up through the CTCSS tones and instantly determines any possible DCS tone. See Page
51 for a listing of the tones that the UBC785XLT decodes.
Note: When Tone Search is active and the scanner finds the subaudible tone used on a
frequency, CTCSS or DCS and subaudible tone flashes. You can press E to pro-
gram that frequency with the found subaudible tone. When you change the mode
to Tone SQ from Tone Search, you can confirm the frequency and subaudible tone
has been programmed.
6/22/06 3:01 PM
36
Page 36
AUTO STORE
SELECT BANK
12--56----
AUTO STORE
ERROR
CH DATA FULL
1245.8500 FM
Bank 12--56----
AUTO STORE
C 001