Important Safeguards - Verilux SmartLight VD12 Instructions Manual

The lamp for learning

Hide thumbs

Table Of Contents

Table of Contents

READ ALL INSTRUCTIONS BEFORE USING

• Do not operate this device near a water source to avoid electrocution.

• Do NOT dismantle.

• Do not use with power supply voltage other than 120 VAC.

• Do not operate lamp in close proximity to ﬂammable or combustible vapors,

such as aerosol spray products, or where oxygen is being administered.

• Do not block vents on ballast. Vents are necessary for proper function of the

ballast; blocking them may cause overheating of the ballast and increase

risk of fire.

• Do not cut or shorten the power cord.

• The bulb in this product contains a trace amount of mercury, a chemical

known to the state of California to cause birth defects or other reproductive

harm. This substance may also cause injury if inhaled or ingested.

• For indoor use only.

• Always unplug lamp before performing bulb replacement or installation.

• This lamp is not for use with light dimmers, timers, motion detectors,

voltage transformers or extension cords.

• This product may cause interference with radios, cordless telephones

or devices that use a wireless remote control, such as televisions. If

interference occurs, move the product away from the device, plug the

product or device into a different outlet or move the lamp out of the line of

sight of the remote control receiver.

• Unplug lamp during lightning storms or when unused for long periods.

• Be very careful not to pinch any part of the cord between any metal pieces.

• Do not use solvents or cleaners containing abrasives, or ammonia based

cleaners on this product.

• All moisture should be properly wiped away and dried prior to restoring

power.

• Do NOT use lubricating agent in assembly; please see troubleshooting

section if you are having difficulty assembling your lamp.

• Disconnect lamp before performing alignment activity.

• Dispose of bulbs per local regulations. For more information on clean-up

and disposal, see http://www.lamprecycle.org.