Table of Contents
Advertisement
1. Make sure that the power cord is unplugged.
With the help of a second person, carefully tip
the treadmill onto its left side. Partially fold the
Frame (55) so that the treadmill is more stable;
do not fully fold the Frame yet.
Cut the shipping tie securing the Upright Wire
(87) to the Base (95). Locate a plastic tie in the
indicated hole in the Base, and use the tie to pull
the Upright Wire out of the hole.
Attach two Base Feet (90) to the Base (95) in the
locations shown with two #8 x 1" Tek Screws (5)
and two Base Foot Spacers (94).
Then, attach the other two Base Feet (90) with
two #8 x 1" Tek Screws (5).
2. See the inset drawing. Cut the plastic tie near
the Upright Wire (87).
Attach a Wheel (96) to the Base (95) with a 3/8"
x 2" Bolt (8) and a 3/8" Nut (10). Do not over-
tighten the Nut; the Wheel must turn freely.
Press a Base Cap (89) into the Base (95).
1
94
90
55
94
2
Plastic Tie
8
96
10
7
Hole
87
5
90
5
87
95
Cut
87
90
5
95
90
5
89
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the PERFORMANCE 400 and is the answer not in the manual?
Questions and answers
I purchased model PFTL59510.0 and I **** in search of a Proform treadmill similar to this one.
The ProForm treadmills similar to model PFTL59510.0 include the ProForm 415 Crosswalk Treadmill (23723.3 / 237233) and the ProForm XP 680 Crosstrainer Treadmill (24646.0 / 246460).
This answer is automatically generated
pro-form 400e starts but won't stay running.
The ProForm PERFORMANCE 400 treadmill may start but not stay running due to several possible reasons:
1. Safety Key Issue – If the safety key is not properly inserted or gets disconnected, the treadmill will stop.
2. Motor or Belt Problem – A faulty motor, loose drive belt, or worn-out walking belt can cause the treadmill to stop.
3. Overheating or Overload – If the treadmill overheats or detects excessive load, it may shut off as a safety measure.
4. Power Supply Issue – Inconsistent power supply, a loose power cord, or a tripped circuit breaker can interrupt operation.
5. Console or Sensor Malfunction – If the console is not detecting movement correctly, it may stop the treadmill.
To diagnose the issue, check the safety key, ensure the belt is properly aligned, confirm the power source is stable, and inspect the motor for overheating.
This answer is automatically generated
My motor seems to be very loud. What could cause it to run loud?
The document does not provide specific reasons for the motor of a ProForm PERFORMANCE 400 running loudly. However, loud motor noise in treadmills is commonly caused by worn motor bearings, a loose or damaged drive belt, or buildup of dust and debris inside the motor area. Regular maintenance and inspection may help identify and resolve such issues.
This answer is automatically generated