Siemens Euroset 3005 User Manual page 3

mounting tab (position 10), according to
detail B.
Detail A
Detail B
Recommendations for Installation
Please, observe the following guidelines:
• For your own safety and protection, do
not uses the telephone in places with
overheat or extreme humidity.
telephone operates at
between 0ºC and +55ºC and it is not
water-proof.
• Varnished or lacquered furniture may be
marked by some parts of the telephone
such as the rubber feet.
• Place the telephone at least one meter
away from devices such as cordless
telephones or TV sets. These devices
may cause interference in the telephone.
• To clean the telephone, just use a damp
or antistatic cloth. Never use a dry cloth
(danger of electrostatic discharge) or any
abrasive cleaning products.
• When the telephone reaches its end of
service life, dispose of it in a way that
does not cause any harm to the
environment, in accordance with the local
legal requirements.
Setting the dialling mode (tone/pulse)
Your telephone must be programmed for
TONE dialling or PULSE dialling, according
to the telephone line it is connected to. The
default factory setting is the TONE dialling
mode with the flash time of 250 ms
(DTMF).
Checking the dialling mode:
Press any numeric key. If you can still hear
a dialling tone, change to the other dialling
mode.
Switching the dialling mode:
The switch located on the bottom of the
telephone allows you to do three settings:
P PULSE
T1 TONE flash 100 ms
T2 TONE flash 270 ms
Temporary changeover of dialling mode:
While the telephone is set to PULSE
dialling it may be necessary to temporarily
change the dialling mode to TONE dialling.
The
temperatures
• Example: You
banking balance using the telebank
service. Make the call as you usually
would and, as soon as the call is
complete, press
telephone dialling mode will change to
TONE dialling. When you finished the
call, just hang up and the dialling mode
2
wish to check your
, at this moment your