Toshiba e-STUDIO222CP User Manual page 44

ITEM
FILE SYS CHK FILE SYS
MAINTE2
CHK ALL
SECTORS
SD CARD
SD CARD ERASE
INITIAL LOCK
SETTINGS EXPLANATION
EXECUTE Executing this function will resolve any
mismatch between the actual and the
displayed free space of the file system and
recover the management data (FAT
information).
Note 1: It takes several seconds to complete
this function.
Note 2: This item is displayed only if the SD
card (option) is installed.
EXECUTE Performs recovery of defective SD Card
sector information and a file system
mismatch mentioned above.
ENABLE Even if a machine is inoperable at
installation because of a faulty SD Card, the
DISABLE
machine can be made operable by setting
this parameter to No (ignores the existence
of the SD Card).
When No is set, access to the SD Card
results in FAIL because the SD Card is
regarded as not attached.
After setting change and exit from the
menu, the printer will restart.
This item is displayed only if the SD card
(option) is installed.
EXECUTE Deletion of all data stored in the SD Card.
Data cannot be recovered. DoD 5220.22-M
sanitizing formula is used for clearing the
card. The printer will restart after changing
the setup menu.
The progress of the procedure is displayed
as a percentage.
The following message appears after
pressing the OK button.
ARE YOU SURE?
YES/NO
If NO is selected, the display will go back to
the source menu, and the procedure for
clearing the disk will start again immediately
after the reboot.
if YES is selected.
The following message appears if the
CANCEL button is pressed.
CANCEL NOW?
YES/NO
If NO is selected, the procedure will
continue.
If YES is selected, the procedure will
discontinue and the printer will restart after
formatting the SD card.
This item is displayed only if the SD card
(option) is installed.
YES If "YES" is selected, you will not be able to
select "ADMIN MENU" - "FILE SYS MAINTE1"
NO
(above).
Menu functions > 44