Wolf CSO24 Installation Manual page 5

Convection Steam Oven Specifications
Convection Steam Oven
The convection steam oven can be installed with or
without side trim in a standard or flush inset application.
The installation opening must have a flat, level base to
support the oven. A minimum base support of 100 lbs
is required. The electrical supply for the oven must
(45 kg)
be located in an adjacent cabinet.
STANDARD INSTALLATION
For standard installations, the convection steam oven is
installed by inserting into cabinetry from the front. The
oven has face trim on the top and both sides that will
overlap stiles and rails. Refer to the chart below for trim
overlaps.
Oven Trim Overlap
Top Overlap
Bottom Overlap
Side Overlap (without trim)
Side Overlap (with trim)
FLUSH INSET INSTALLATION
For flush inset installations, a minimum
required on all four sides. The inside edges of the rough
opening must be finished, as they will be exposed when
the oven door is open. These edges should be stained
instead of having a laminated surface, to avoid damage
from high temperatures and steam.
3
/ "
(5)
16
0"
(0)
5
/ "
(16)
8
13
3 / "
(97)
16
1
/ " reveal is
(3)
8
COMBINATION INSTALLATIONS
The Wolf convection steam oven with trim is designed
and agency approved for installation with Wolf cooktops,
built-in ovens, microwaves and warming drawers only.
If it is being installed above or below an E series oven in a
flush inset application, a
For typical combination installations, refer to the illustra-
tions on pages 9–11.
wolfappliance.com/specs
1
/ " reveal is required.
(6)
4
5