General Maintenance Instructions - Husqvarna K650 Cut-n-break Operator's Manual

MAINTENANCE

General maintenance instructions

Below you will find some general maintenance instructions. If you have more questions, contact your service agent.
Daily maintenance
1 Check that the components of the throttle control work smoothly (throttle control and throttle trigger lock).
2 Clean the outside of the machine.
3 Check the tension of the drive belt.
4 Check the condition of the blades and the drive gear.
5 Check the condition of the blade guards.
6 Check the starter and starter cord and clean the outside of the starter unit's air intake.
7 Check that nuts and screws are tight.
8 Check that the stop switch works correctly.
9 Check the function of the restrictor.
Weekly maintenance
10 Check the condition of the air filter.
11 Check that the handles and vibration damping elements are not damaged.
12 Clean the spark plug. Check that the electrode gap is 0.5 mm.
13 Clean the fins on the flywheel. Check the starter and the recoil spring.
14 Clean the cooling fins on the cylinder.
15 Check that the muffler is securely attached and not damaged.
16 Check the operation of the carburettor.
Monthly maintenance
17 Check the clutch centre, drive gear and clutch spring for wear.
18 Clean the outside of the carburettor.
19 Check the fuel filter and the fuel hose. Replace if necessary.
20 Clean the inside of the fuel tank.
– 21
English