Fuses
Fuses are located on the right hand side of the
machine. They are accessed by tilting the seat
forward. Fuses are flat pin fuses type as used in
automobiles.
There are three fuses with ratings and functions:
1. 20 A, Primary fuse.
2. 7.5 A, Mower deck coupling.
3. 10 A, Accessories
Choke Control
The choke control is used for cold starts to provide
the engine with a richer fuel mixture.
For cold starts the control should be pulled out to its
extent.
Cutting Height Controls
The cutting height pedal lifts the deck to allow setting
the desired deck height. For transport, push the lift
pedal fully forward until the deck lift latches in the
transport (highest) position.
To set the deck cutting height, release deck height
control by pushing forward on the pedal. Rotate the
cutting height pin 180
O
into the hole for the desired cutting height. The cutting
height can be set from 1"- 5½" (2.5 cm-14 cm).
CONTROLS
to remove it and slip the pin
Fuses
Choke control
Cut height lift pedal
8065-043
8065-085
8065-087
23