BBQ GSF2818KM Owner's Manual page 9

Step 4 (The heat insulation panel assembly)
a) Align the two holes on cart left side panel (K) with the
two holes on heat insulation panel (H).
b) Insert one bolt (AA) with one spring washer (CC) and
one flat washer (BB) into each pre-drilled holes. Tighten
bolts by hand until secure.
c) Repeat the procedure for the heat insulation panel and
cart right side panel assembly.
d) Tighten all bolts using the screwdriver provided.
Step 6 (Grease cup & support
assembly)
a) Hook the grease cup support
(I) into the two holes on the
heat insulation panel.
b) Place the grease cup (J) onto
the grease cup support.
GSF2818KM
Owner's Manual
Step 5 (Cart bottom panel assembly)
a) Place the cart bottom panel (M)
onto the cart bottom frame as
shown, make certain the two ears
of the bottom panel are under the
bottom frame. (See the left
diagram).
Step 7 (Tank clip and tank support assembly)
a) Insert the tank clip (BBB) into the two holes
on the cart bottom panel as shown.
b) Loosen two pre-installed bolts on the tank
support (AAA) and allowed 1/4 bolt's length
to extend from tank support.
c) Hang the two pre-installed bolts on the hole
of right side panel (X) and push them down
to place.
d) Go back and tighten all the bolts using
screwdriver provided.
8