GE AG_14 Owner's Manual & Installation Instructions page 13

7
Install the Window Locking Bracket and the Foam Top Window Gasket
Attach the window locking bracket with a
A
type C screw.
8
Install the Air Conditioner in the Case
Slide the air conditioner into the case.
A
Reinstall the 2 screws removed earlier on each
side of the case.
Before installing the front grille, pull out the
B
vent control lever located above the unit
control knobs, as shown.
Cut the foam top window gasket to the window
B
width.
Stuff the foam between the glass and the
C
window to prevent air and insects from getting
into the room.
Attach the front grille to the case by inserting the
C
tabs on the grille into the slots on the front of the
case. Push the grille in until it snaps into place.
Guide the lever carefully
through the grille as you
push it in.
Lift the inlet grille and secure the front frame
D
with a type A screw. Lower the inlet grille into
place.
13