Assembly & Adjusting; Mounting Scroll Saw To Workbench - Makita SJ401 Instruction Manual

Assembly & Adjusting
MOUNTING SCROLL SAW
TO WORKBENCH
I
WARNING: Turn off saw and unplug before making
any adjustments.
When mounting this saw to a workbench, a solid bench is
preferable to a plywood bench where noise and vibration
will be more noticeable.
Hardware to mount this saw to a workbench is NOT
SUPPLIED with the saw. However, we recommend the
hardware used be no smaller than the following. I 1
r
I I
Quantity Description ; I
3 Hex Head Bolts, 1/4-20 Length
; I
Required
I 1
3 Flat Washers, 9/32 I.D.
! I
3
Lockwasher,
9/32 I.D.
6 Hex Nuts, 1/4-20
Example of mounting this scroll saw to workbench, as
shown.
SETING THE TABLE FOR
HORIZONTAL OR BEVEL CUlTlNG
1. Loosen the table lock knob, and the saw table can be
tilted to the left and locked at any angle from 0 degree
horizontal cutting position up to 45 degrees for bevel
cutting
2. A degree scale is also provided under the work table as a
convenient reference for setting the approximate table
angle for bevel cutting. When greater precision is re-
quired, make practice cuts and adjust the table as neces-
sary for your requirements.
3.
NOTE: When cutting at angles, the hold down can be
tilted so it's parallel to the table and rests flat against the
workpiece. To tilt foot, loosen allen screw, tilt foot so it's
parallel to table and securely tighten screw.
a