HP iPAQ hx4700 User Manual page 102

4. Set up your Dialing Rules and Exceptions and press OK.
The next step is to setup your network interface cards.
5. From the iPAQ Wireless screen, tap > Settings.
6. Select Add New ... in the list box on the General tab to start
configuring wireless networks.
Note:
automatically entered and cannot be changed.
7. Enter a SSID into the Network Name box.
8. In the Connects to: box, select where your network connects
to (The Internet or Work).
9. If you want to connect to an ad-hoc connection, tap the This
is a device-to-device (ad-hoc) connection checkbox.
10. If authentication information is needed, from the Configure
Wireless Network screen, tap the Network Key tab.
Note:
needed, see your network administrator.
11. To configure the type of network authentication to use, select:
a. To use Shared Key authentication, tap the
b. To use data encryption, tap the Data encryption
c. If a network key is provided by your network
User's Guide
If a network was detected in step 3, the SSID is
To determine whether authentication information is
Authentication (Shared mode) listbox. Type the
network key in the Network Key: box.
(WEP enabled) listbox.
automatically, tap the The Key is provided for
me automatically checkbox.
Using Wi-Fi
8–4