GE 29869 User Manual page 3

INstlrr-qrroN
/ . , - . : . , , : i i . r . . : . .
F 1*?!r", I
?
|
. - e - _ " . J
*---
Answerer
Pmrs Cnrcrs,rsr
Make sure your package includes the following items:
1. Plug the telephone line cord into a modular wall jack.
r-, F
2 *
2. Connect the telephone line cord from your
telephone into the jack on the back of the answerer
marked PHONE. (You don't have to connect your
telephone in order for the answerer to record
incoming messages.)
3. Connect the small end of the power supply into the
POWER 9V AC jack on the back of the answerer. Plug
the other end into an AC power outlet.The unit beeos
3 times and is ready for setup or to answer calls with
the default greeting and settings.
wf,
M/
AC power supply
W
ruN
Telephone line cord
Monur-m J,t cx RnqunnuENTs
You need an RJ11 type modular jack, which is the most common type
of phone jack and might look like the one pictured here installed in
your home. lfyou don't have a modularjack, call your local phone
company to find out how to get one installed.
INsrer.r,rNc rHE BATTERY
In the event of a power loss, a 9-volt battery (not included) enables
the answerer to retain greetings and messages stored in memory.To
install the battery:
1. Remove the battery compartment door on the bottom of the unit
by loosening the screw with a Phillips
screwdriver. Lift the door.
2. Connect a fresh 9-volt alkaline battery (not included). The large
and small contacts on the battery clip and the battery will
interlock. Once connected, place the battery inside the battery
comDartment.
3. Replace the battery compartment door and tighten the screw.
NOTEr If the battery is low or not installed, the unit announces
"
Lou Battuli' at the end of message playback.
Wall plate
Mod'lar f' 1
telephone I El ll
rnelackA_J
Battery compartment
door
\ : l
l l - r - l
[_
-,|
Battery clip
- \ +
\CD
Battery ,4$
\ . 1
l t l
A
nrsrAuAToNrMoRMAnoN
o Never install telephone wiring
during a lightning storm.
o Never touch uninsulated telephone
wires or terminals, unless the
telephone line has been
disconnected at the network
interface.
o Use caution when installing or
modiling telephone lines.
CAUTION: Only use the ATLINKS USA, Inc. 5-2434A (white),2F,2418A (black)
power supply that was packed with this unit. Using other power supplies may
damage the unit.