Switch Housing - Hunter ceiling fan Installation Manual

Switch Housing

Screw two (2) housing assembly screws
from the hardware bag halfway into
the motor housing. It does not matter
which two screw holes you choose.
Feed the wire plug through the center
hole of the upper switch housing, then
wrap keyhole slots around the screws and
twist counterclockwise.
10
M0024-01 • 11/28/12 • © Hunter Fan Company
www.HunterFan.com
Insert the third screw, found in
the hardware bag, into place and then
tighten all three (3) screws.
Make sure the upper switch housing is securely
attached to the mounting plate. Failure to properly
secure all three assembly screws could result in the
switch housing fixture falling.
1.888.830.1326