Span Setting Mode - Hunter 44277W Installation And Operation Manual

iCons anD feaTures, ConT.
3. Span setting mode – allows you to adjust the
system ON/OFF cycle rate. The default setting
is 2 (the system cycles ON or OFF when the
o o
temperature is within 1 F (0.5 C) above and
below the set temperature.) The span setting
can be adjusted if your system is cycling too fast
or too slowly.
Press and hold both the and buttons
Up Down
until the word SPAN appears. Use the or
Up Down
button to adjust the span setting.
(Up will increase your cycle time by allowing the system to
run longer; Down will decrease your cycle time by causing
the system to run for a shorter length of time.)
Span settings remain the same for and
HEAT
system settings. When batteries are
COOL
installed, or the unit is , the span cycle will
RESET
revert to 2.
41