Extron electronics CrossPoint 450 Plus Series Setup Manual page 16

Command
Audio output volume
Set the audio volume to a specific
value
Example:
Increment volume
Example:
Decrement volume
Read output volume
Save and recall presets
N • If you try to recall a preset that is not saved, the matrix switcher responds with the error code E11.
• The following characters are invalid in preset names: + - , ` @ = [ ] { } ' " ; : | \ and ?.
Save current configuration as a
global preset
Example:
Recall a global preset
Example:
X@
= Output number
N
X%
= Volume
X^
= Preset number
Command
Lock (executive) modes
N See "Setting the front panel locks (Executive modes)" on page 3-4 for more information on the Lock modes.
Lock all front panel functions
Lock advanced front panel functions
Unlock all front panel functions
View lock status
X&
= Lock mode
N
ASCII command Response
(host to switcher) (switcher to host)
X@ X% X@
* V Out
1*50v
Out01•Vol50
X@ X@
+V Out
1+V
Out01•Vol51
X@ X@
-V Out
X@ X%]
V
X^ , X^]
Spr
]
,
9 Spr09
X^ . X^]
Rpr
]
.
5 Rpr05
01 – (maximum number of outputs for your model)
0 – 64 (1 dB/step except for 0-to-1, which is 22 dB) (default = 64 [0 dB])
00 - 64 (00 = current configuration, for viewing only)
ASCII command Response
(host to switcher) (switcher to host)
]
1X
Exe1
]
2X
Exe2
]
0X
Exe0
X&]
X
0, 1, or 2
Additional description
X%]
•Vol
]
Set output 1 volume to an
attenuation of 14 dB (79% of total volume).
X%]
Increase volume by 1 step.
•Vol
]
X%]
Decrease volume by 1 step.
•Vol
Command character is a comma.
Save current ties as preset 9.
Command character is a period.
Recall preset 5, which becomes the current
configuration.
Additional description
Enable Lock mode 1.
Enable Lock mode 2.
Enable Lock mode 0.
X%
value of 50, an